13
Problem
Check Point
Cause
Solution
The Spin Dryer
does not rotate.
Is the Motor hot?
(In case there is Thermal Protector)
Is the Wiring good?
(Refer to the Wiring Diagram)
Is the Door Switch Lever properly
placed on the Door Spin *O?
Assemble after loosening
Link Brake and
adjusting downward.
Power restored when
Motor cools
Power has been cut off
by the Thermal Protector
Improper wiring.
Defective connection
Improper wiring
Reconnect the wiring.
Replace Door Switch or
reshape the Lever.
Reconnect the terminal.
Replace the Spin Motor.
Replace the Spin Timer.
Reload the clothes so they
are well balanced.
Tighten the Bolt in Drum
Coupling Assembly
Reload the clothes and
press down the Safety
Cover into Spin Basket.
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
There are strange
noise and severe
vibration during
spinning.
Is the Door Switch terminal properly
connected?
Is the contact of Spin Timer good?
Is the wash load well balanced?
Are clothes or the Safely Cover
stuck out of the Spin Basket?
Is the assembly between the Drum
Coupling Assembly and Spin Motor
or Spin Dryer loose?
Is The Spin Dryer itself well Balanced?
Tub is in contact with the
object stuck out.
Improper structural assembly
Spin Dryer unbalance Re-assemble Spin Dryer.
Defective Spin Motor
Defective Spin Timer
Spin Dryer does not
balanced due to wash load.
Brake wire is too long
The Brake Band is touching
the Drum coupling Assembly.
NO
NO
NO
To Next Page
Loading...
