Washing procedure and program selection (cont.)
1
Put the laundry into the Drum, Then close the door.
The close the door.
2
Press the Power button.
• The LED shows only ‘- --’ signal.
3
Select the ‘Cotton Dry’ program using program selection dial.
• Dry option ‘Cup board’ is selected automatically.
• If you want to change dry option, press the button.
4
Press Start/Pause button.
• The washer will be operated with locking door supplying water after sensing the
amount of laundry automatically.
* COTTON DRY
NOTE
• Suitable dry for the cotton.
• Do not use the detergent and softener.
• Cold water tap should be opened.
• After finishing this program,
is showed on PCB board alternately and the smoothing creases program is
conducted during 30 minute and then power is OFF.
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not
previously.
• If the dry performance is poor, change the selecting temperature.
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause' button.
To Next Page
Loading...
