To Next PageTo Next PageWhy is my Daewoo DWD-F1011 making a vibrating noise?
If your Daewoo washer is making a vibrating noise, ensure all transit bolts and packing have been removed during installation, referring to the Installation Guide if needed. Also, check that all the feet are resting firmly on the ground. An uneven wash load may also cause vibration; stop the washer and rearrange the load.
What to do if the door on my Daewoo DWD-F1011 won't open?
If your Daewoo washer door won't open, wait two minutes to give the electric locking mechanism time to release for safety reasons.
How to fix a Daewoo DWD-F1011 that won't drain?
If your Daewoo washer isn't draining water, or is draining slowly, inspect the drain hose for kinks or clogs and clean and straighten it. Also, check the drain filter for clogs and clean it.
What does H8 error mean on my Daewoo DWD-F1011?
To address the H8 HEATER WASH OVERHEATING ERROR on your Daewoo washer, check the water level and the heater wash.
Why is my Daewoo DWD-F1011 oversudsing?
If your Daewoo washer is oversudsing, too much or unsuitable detergent may be the cause, leading to excessive foaming and potential leaks.
What does E5 error mean on my Daewoo DWD-F1011 Washer?
To resolve the E5 HIGH VOLTAGE ERROR on your Daewoo washer, rearrange the laundry if it's jammed between the gasket and the drum. If the problem persists, the PCB ASS’Y may need to be replaced.
How to fix PFE PUMP FILTER ERROR on Daewoo DWD-F1011 Washer?
To resolve the PFE PUMP FILTER ERROR on your Daewoo Washer, clean the drain pump filter. If problems persist you should change the drain pump. Also use the proper amount of detergent and place the drain hose 1m below the floor.
Why does my Daewoo DWD-F1011 show a water inlet error?
A water inlet error on your Daewoo Washer can occur for several reasons: * The water tap might be closed; in this case, open the water tap. * The filter of the valve inlet could be clogged; clean the filter. * The valve inlet or the water level sensor might be defective, requiring replacement. * The drain motor may be running during water supply, also requiring replacement. * The PCB ASS’Y might not be checking the water level, also requiring replacement.
How to troubleshoot E6 EMG ERROR on Daewoo Washer?
To resolve the E6 EMG ERROR on your Daewoo Washer, rearrange the laundry to ensure it is not jammed between the gasket and the drum. If problems persist you should change the motor or the PCB ASS’Y.
What to do if my Daewoo DWD-F1011 does not start?
If your Daewoo Washer won't start, ensure the power cord is securely plugged into the wall outlet. A loose connection can prevent the washer from starting. Also, check your house fuse or circuit breaker. If a fuse is blown or the breaker is tripped, reset the breaker or replace the fuse. Finally, make sure that the water supply tap is turned on.
General| Loading type | Front loading |
|---|---|
| Capacity | 6 kg |
| Washing capacity | 6 kg |
| Maximum spin speed | 1000 RPM |
| Dimensions (H x W x D) | 85 cm x 60 cm x 55 cm |
| Noise Level (Washing/Spinning) | 58 dB / 76 dB |
| Color | White |
| Type | Washer |
| Water Consumption | 49 L |
