To Next PageTo Next PageWhy does water enter my Daewoo DWD-FC1231 Washer slowly?
If water isn't entering your Daewoo Washer properly, check if the water supply is adequate. Then, fully open the water supply tap. Straighten the water inlet hose if it's kinked and check the filter of the water inlet for any clogs.
How to stop rattling noise in Daewoo Washer?
If your Daewoo Washer is making rattling or clanking noises, there might be foreign objects in the drum or pump. Stop the washer and check both the drum and the filter.
Why is my Daewoo DWD-FC1231 making a thumping sound?
A thumping sound in your Daewoo Washer is usually normal with heavy loads. However, if the sound continues, stop the washer and redistribute the wash load to balance it.
What causes oversudsing in a Daewoo DWD-FC1231?
Excessive foaming in your Daewoo Washer may be due to too much or unsuitable detergent, which can cause water leaks.
Why is the wash cycle time delayed on my Daewoo DWD-FC1231?
The washing time in your Daewoo Washer may vary based on the amount of laundry, water temperature, and other conditions. If an imbalance is detected, the wash time may increase.
What to do if Daewoo DWD-FC1231 stops during spinning?
If your Daewoo Washer stops during spinning and displays a PFE error, turn off the machine. Then, turn it back on, press the SPIN button, and then press the Start/Pause button.
Explains the purpose of transit bolts and the procedure for their removal and reinstallation.
Outlines the necessary conditions for the installation location, including floor level and clearance.
Details the steps for connecting the inlet hose to both ordinary and screw-shaped taps.
Explains how to properly install the drain hose to prevent damage and ensure correct drainage.
Guides on how to adjust the machine's feet for proper leveling to prevent noise and vibration.
Explains how to clean the water inlet filter, especially when an "IE" error occurs.
Details the procedure for cleaning the drain pump filter to ensure smooth operation.
Step-by-step instructions for removing and disassembling the door lock switch.
Guides on how to disassemble the heater and thermistor components.
Details the process of removing the universal motor from the washing machine.
Provides instructions for removing the drain pump assembly.
Displays an exploded view of the box inlet assembly with numbered parts.
Lists parts for the box inlet assembly, including part codes and specifications.
Outlines the sequence chart for Cotton, Synthetic, and Eco programs, showing progress times.
Details sequence charts for Wool, Delicate, Sports wear, Hand wash, and Quick 30 courses.
Explains the sequence chart for the Islamic Rinse option with Cotton/Normal course.
Details how to use the test mode to check PCB and machine operations, including error codes.
Provides a table listing common symptoms, their causes, and recommended solutions.
Details various error messages (IE, OE, UE, LE, E2, etc.) and their corresponding causes and solutions.
Illustrates the wiring connections to the main PCB and various components.
General
