PAUSING WASHING
It is possible to stop the wash cycle by pressing
the Start/Pause button. The machine will go to
standby mode. If there is a need to change the
programme, the dial No. 1 must be turned to
OFF position before selecting new programme.
At the end of the wash cycle, the red LED turns
off and the door can be opened only if the drum
is not empty of water.
LOADING LAUNDRY INTO THE DRUM
For proper washing, it is necessary to load the
drum possibly with loose laundry one at a time.
This is to prevent nodes. The washing efficiency
amount of laundry. In general, an excessive or
less than half the rated capacity (see technical
data table page 2), puts strain on the ‘reliability
of the washing machine and generates more
noise in the machine.
In the case of excessive loads or below
the nominal capacity and uneven, it is
appropriate to minimize the spin speed to
avoid strong vibrations during spinning.
only at temperatures above 50°C, as in the
liquid detergent there is no sodium perborate,
but the optical bleaching agent that works well
only beyond a certain temperature.
Recommended temperature cold - 90°C
SOFTENER
The softener is very high concentrate, which
them soft. It should be used sparingly or diluted
with water, 50% and more. It facilitates ironing
of clothes washed.
The fragrances are due to different essences
added to the detergent and do not in any way
impair the ability of cleaning product.
DETERGENT DOSES
The doses vary depending on the type of water:
with hard or averagely hard water it takes a
greater amount of product compared to that
soft water, as is typically printed on the label of
the various products. In general, using quality
products, very little quantity of detergent would
be enough, and to always use 20% less than
usual can not go wrong!
STARTING WASHING PROGRAMME
1. To start the washing program turn the
programme selection dial onto the desired
programme.
Evaluate the opportunity to customise
the washing programme by adjusting the
temperature with the dial No. 2, the spin
(button 6) or selecting one or at most 2 of the
special functions provided.
STARTING WASHING
After the steps above washing can be started
by pressing the Start/Pause button.
is strongly influenced by the way and the
DWD-M_DWD-FI.indd 19 2015-05-27 오전 10:39:10
To Next Page
Loading...
Need help?
General
