POSSIBLE REMEDIES
Problem
LED
Alarm
LCD
Alarm
Possible Solution
The machine does not turn on
or start
• Make sure that the power plug is inserted.
• Make sure there is power in the socket.
• Make sure that the selector switch, pro-
gramme selector knob 1, is not in the OFF
position.
The machine turns on but
does not start and LEDs No.
F1 appears on display (LCD
model) .
o
o
●
●
F1
• Make sure the door is well closed
ekat ton seod enihcam ehT
(LED model) or F2 appears
on display (LCD model) .
o
●
o
●
F2
• Make sure there is water supply.
• Make sure the water tap is opened.
• Make sure the water inlet hose is not
squashed.
•
clogged
(LED model) or F3 appears
on monitor (Display model).
o
●
●
o
F3
• Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
The machine does not empty,
does not spin and LED 1 and
-
pears on display (LCD model)
●
o
o
●
F4
•
clogged. See page 22.
• Make sure the rinse hold special function
is enabled.
• Make sure that the drain hose is not
squashed and the internal diameter of
the drainage is larger the that of the drain
hose.
Repairs executed incorrectly can seriously threaten the safety of user.
The vast majority of failures and faults that occur in daily use of the machine can be eliminated
tcatnoc ot gnivah ylirassecen tuohtiw devas eb dluoc stsoc dna emit sesac ynam nI .yllanosrep
The manufacturer srl authorized technical service centre.
The following table will aid to identify and possibly eliminate the causes of failure/malfunction.
However, note that:
!
LED number 2 and 3 flash
DWD-M_DWD-FI.indd 22 2015-05-27 오전 10:39:10