Problem
LED
Alarm
LCD
Alarm
Possible Solution
(LED model) or F5 is dis-
played (Display model).
●
o
●
o
F5
• Switch off and then switch on the wash-
ing machine. If the fault persists contact
an authorised service centre.
(LED model) or F6 is dis-
played (Display model).
●
o
●
●
F6
• Switch off and then switch on the wash-
ing machine. If the fault persists contact an
authorised service centre.
The door does not open
• Make sure the red pilot lamp turns off.
• Make the special function SOAK or RINSE
HOLD is not activated
• Push the door from the door locking side
or give a slight tap and at the same time
pull it to open.
• Make sure both the water inlet hose and
drain hose are whole and do not leak.
• The washing detergent could not be ideal
or could be excessive.
• Reduce the detergent quantity.
in water even when it is off.
• Reduce the pressure of water supply or
the water pressure pumping system (wa-
ter autoclave).
• Tap should be off when washing has done.
The machine vibrates notice-
ably.
• Ensure that the transportation screws
have been removed during installation.
•
clean. Ensure that the drain pump is
squashed and that the machine drains ef-
fectively.
• Ensure using the correct detergent for
washing machine.
• Make sure that the laundry is not amassed
or knotted and that the spin speed is ad-
equate for the laundry load. It so recom-
mended that for excessive laundry load
and less than half the nominal load capac-
ity set the spin speed to low.
• Ensure that the machine is properly lev-
for any eventual feet imbalance compen-
sation the feet must regulated and lock
them in place with the locking knob (see
).
LED number 2 and 4 flash
LED number 1, 2 and 4 flash
The washing machine pelting
DWD-M_DWD-FI.indd 23 2015-05-27 오전 10:39:11
To Next Page
Loading...
Need help?
General
