Daewoo FRS-U20IV - HOW TO CHECK EACH PART (Ice Maker Components); Ice Maker Disassembly & Check

4. Dispenser Solenoid Valve (Dispenser Models Only)
1) Disassembling Procedure (Features are model dependent)
HOW TO CHECK EACH PART
No No
5
4
Procedure
Disassemble the Cover dispenser Box As
2
Procedure
1
Disconnect 2 terminals and 2P Wire.
U d Sl id Vl
Separate Front PCB connector.
(Features are model dependent )
2) How to check Dispenser Solenoid Valve
36
U
nscrew
an
d
remove
S
o
l
eno
id V
a
l
ve.
(Features are model dependent
.
)
Unscrew and remove Cover Ice Flap.Unscrew to remove Box Dispenser Ice Shut.
( Good ): 215 Ohm (+-10%)
(193 ~ 236 Ohm)
(Defective): Change the part.
( Good ): 96 Ohm (+-8%)
(88 ~ 104 Ohm)
(Defective): Change the part.
Check the resistance of
both terminals.
Check the resistance of
2 terminals with a Tester.
Flap Heater Assembly
Dispenser Solenoid Valve
Parts How to Check Remark
33