Maintenance Section
-136-
Drive Axle Oil
NOTE: Do not use Gear Oil in the final drives or
differentials. Gear Oil can cause seal
material to fail and possibly leak oil.
NOTE: Failure to follow the recommendation will
cause shortened life due to excessive gear
wear.
The API CD/TO-2 specification or MIL-L-2104D, Eor
F oils could be used.
NOTE: Multi-grade oils are not blended by
DAEWOO for use in transmissions.
Multi-grade oils which use high molecular
weight polymers as viscosity index
improvers lose their viscosity effectiveness
by permanent and temporary shear of the
viscosity index improver and therefore, are
not recommended for transmission and
drive train compartments.
Lubricating Grease (MPGM)
Use Multipurpose Molybdenum Grease (MPGM) for
all lubrication points. If MPGM grease can not be
used, multipurpose type grease which contains 3%
to 5% molybdenum disulfide can be used.
NLGI No.2 grade is suitable for most
temperatures. Use NLGI No.1 or No.0 grade for
extremely low temperature.
Transmission Oil
NOTICE
This oil is formulated for transmissions and drive
trains only, and should not be used in engines.
Shortened engine life will result.
NOTE: Multi-grade oils are not blended by
DAEWOO for use in transmissions.
Multi-grade oils which use high molecular
weight polymers as viscosity index
improvers lose their viscosity effectiveness
by permanent and temporary shear of the
viscosity index improver and therefore, are
not recommended for transmission and
drive train compartments.
NOTE: Failure to follow this recommendation can
cause shortened transmission life due to
material incompatibility, inadequate
frictional requirements for disk materials
and/or excessive gear wear.
The API CD/TO - 2 specification or MIL - L 2104D, E
or F oil could be used.
To Next Page
Loading...
Need help?
General
