Operation Section
-81-
Dual Fuel System (If G424 Dual Fuel Engine Equipped)
Changing From Gasoline to LP –
Gas
NOTE: The Underwriter’s Laboratory (U.L.)
requires that the gasoline tank must be at
least one - quarter full when operating on
LP - Gas. This will allow the lift truck to be
restarted on gasoline and moved to an
approved refueling area, when operating in
a hazardous area.
1. Park the lift truck level in an authorized refueling
area with the forks lowered, the parking brake
applied, the transmission in NEUTRAL and the
engine running.
2. Raise the hood and seat assembly. Make certain
the air lift cylinder securely holds the hood open.
3. Move lever (1), on the fuel selector switch to the
OFF (2) position. Leave lever (1) in this position
until the gasoline in the carburetor is used and
the engine stops.
4. Move lever (1) to the LPG (3) position.
5. Lower the hood and seat assembly.
6. Open the fuel valve, on the LP - Gas tank, by
slowly turning the valve counterclockwise.
7. Turn the ignition switch key to the OFF position
and then to the START position to start the
engine. Release it when the engine starts.
Changing From LP - Gas to
Gasoline
1. Park the lift truck level in an authorized
refueling area with the forks lowered, the
parking brake applied, the transmission in
NEUTRAL and the engine running.
2. Close the fuel valve on the LP - Gas tank. Allow
the engine to run until the fuel in the line runs
out and the engine stops. Turn the ignition
switch to the OFF position.
3. Raise the hood and seat assembly. Make
certain the air lift cylinder securely holds the
hood open.
To Next Page
Loading...
Need help?
General
