Maintenance Section
-155-
Mast Channels – Lubricate
The channels on the roller-type mast require a
break-in period. Apply a light film of lubricant on the
channels where the rollers ride. This will prevent
metal peel until the rollers set a pattern.
Transmission Oil Level – Check
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
1. Start and operate the lift truck until the engine
reaches normal operating temperature.
2. Park the lift truck level with the forks lowered,
parking brake applied and the transmission
controls in NEUTRAL.
3. With the service brake applied and the engine
at low idle, shift the directional control lever to
forward and then to reverse, to fill the clutches.
4. Shift the direction control lever to the NEUTRAL
position.
5. Remove the dip stick/filter cap. Observe the oil
level.
6. Maintain the oil level between the Min and Max
marks on the dip stick/filter cap.
When the oil temperature is 40°C approximately,
the cold side mark on the dipstick is applicable.
When the oil temperature is 80°C approximately,
the hot side mark on the dipstick is applicable.
To Next Page
Loading...
Need help?
General
