| 9 |
- This washer is available for use with cold water only.
Do not connect the inlet hose to the hot water tap.
Connect the drain hose to the drain.
- Check that the drain hose is tightly connected.
- A minor water leak may occur during installation or the initial cycle. The leak is
caused not by a malfunction or a mechanical problem but by the remnant for
functional test performed at the manufacturing plant.
1
Connect the inlet hose and turn on the tap.
- Check whether any leaks occur around the hose guide or inlet hose connection.
Plug in the power cord.
- Check the grounding procedure to prevent electric shocks.
Preparation
Caution
2
3
미니(1.5)_DWD-CV702WP(영).indd 9 2017-11-24 오후 6:37:19
To Next Page
Loading...
