EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
5-4
©
200518
Draining and filling
5
ΧΦ65/65 (II) series
If the vehicle is fitted with water cab heater
1. Run the engine at idling speed.
2. Switch on the cab heater using the rocker
switch on the dashboard.
3. Turn the heater temperature control knob in
the cab to the maximum "hot" setting.
4. Switch on the heater fan.
5. Set the rocker switch on the thermostat in the
cab to position 1.
Note:
Combustion will start after approximately
one minute.
6. Allow the cab heater to operate for
approximately 15 minutes.
7. Check the coolant level again; top up with
coolant if necessary.
Drive and chas sis
https://www.truck-manuals.net/
To Next Page
Loading...
