©
200515 4-15
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΛΦ45/55 series
5
4.11 REMOVAL AND INSTALLATION, F36/F48 FRONT AXLE HUB SEAL
Removing the hub seal
1. Remove the seal from the hub using the
special tool (DAF no. 1329458). Make sure
that the chamber is not damaged during this.
Installing the hub seal
1. Fit special tool (A) (DAF no. 1329485) for
the F36 front axle and (DAF no. 1329484)
for the F48 front axle) in the driving tool (B)
(DAF no. 0499809).
2. Using the special tool, fit the new seal (1) in
the hub (2). The open side of the seal (1)
must face the hub (2). Apply a little grease to
the sealing lip of seal (1).
Drive and chas sis
A
B
1
2
S7 00 588
https://www.truck-manuals.net/
To Next Page
Loading...
