DAF LF45 - Page 98

EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-14
©
200515
Removal and installation
5
ΛΦ45/55 series
20. Apply locking compound to the attachment
bolts (3) of the brake calliper (2). See
"Technical data".
21. Install the brake calliper (2). Tighten the
attachment bolts (3) in the specified
sequence to the specified torque. See
"Technical data".
22. Set the brake pad clearance. To do this, turn
the adjusting bolt (1) anti-clockwise until the
brake pads abut the brake disc. Then turn
the adjusting bolt (1) clockwise through 90.
Check that the brake disc runs freely.
23. Fit the cap on the adjusting bolt (1).
24. Install the wheel speed sensor (1) and press
it against the sensor ring. The required
clearance will be produced while on the
move.
25. Fit the wheel.
R600559
1
2
3
3
1
S7 00 589
https://www.truck-manuals.net/