User's Manual
150
Trigger
Configure the triggering parameters.
Table 5-39 Trigger parameters
Period
Click
to display set interface.
Define a period during which the motion detection is active. For
details, see "Setting Motion Detection Period" section in "5.10.1.1
Configuring Motion Detection Settings."
Alarm Out
Click
to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Latch
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the
check box to enable a pop-up message in
your local host PC.
Alarm Upload
Select the
check box to enable the system to upload
the alarm signal to the network (including alarm center) when an
alarm event occurs.
Send Email
Select the
check box to enable the system to send an
email notification when an alarm event occurs.
To Next Page
Loading...
Need help?
General
