User's Manual
162
HDD interface
Configure the settings for the HDD event.
Table 5-44 HDD event configuration
Event Type
In the
list, select
,
, or
as the
event type.
Enable Enable or disable the HDD event detection function.
Alarm Out
Click
to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Latch
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the
check box to enable a pop-up message in your
local host PC.
Alarm Upload
Select the
check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.