EasyManuals Logo

Dahua Technology DHI-XVR5108HS-4K User Manual

Dahua Technology DHI-XVR5108HS-4K
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #177 background imageLoading...
Page #177 background image
User's Manual
169
Parameter
Description
Latch
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the
Show Message
check box to enable a pop-up message in your
local host PC.
Alarm Upload
Select the
Alarm Upload
check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.
Send Email
Select the
Send Email
check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > EMAIL
.
Record Channel
Select the channel(s) that you want to record. The selected channel(s) starts
recording after an alarm event occurs.
The recording for alarm and auto snapshot must be enabled. For details, see
"5.1.4.9 Configuring Recorded Video Storage Schedule" and "5.9.1 Enabling
Record Control."
PTZ
Click
Setting
to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the preset that
you want to be called when an alarm event occurs.
Post Record
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Tour
Select the
Tour
check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured in
Main
Menu > DISPLAY > TOUR
.
Snapshot
Select the
Snapshot
check box to take a snapshot of the selected channel.
To use this function, make sure the following settings are configured:
The snapshot function is enabled for motion detect alarms in
Main
Menu > STORAGE > SCHEDULE > Snapshot
.
Select
Main Menu > CAMERA > ENCODE > Snapshot
, in the
Mode
list,
select
Event
.
Video Matrix
Select the check box to enable the function. When an alarm event occurs,
the video output port outputs the settings configured in "
Main Menu >
DISPLAY > TOUR
."
Not all models support this function.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dahua Technology DHI-XVR5108HS-4K and is the answer not in the manual?

Dahua Technology DHI-XVR5108HS-4K Specifications

General IconGeneral
BrandDahua Technology
ModelDHI-XVR5108HS-4K
CategoryDVR
LanguageEnglish

Related product manuals