User’s Manual
258
Parameter Description
More Setting
Show Message: Select the Show Message checkbox to enable a pop-
up message in your local host PC.
Buzzer: Select the checkbox to activate a buzzer noise at the Device.
Video Matrix: Select the checkbox to enable the function. When an
alarm event occurs, the video output port
configured in Main Menu > DISPLAY > Tour.
This function is available on select models.
Send Email: Enable the system to send an email notification when an
alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Log: Select the checkbox to enable the Device to record a local alarm
log.
Extra screen: Select the checkbox to enable the function. When an
alarm event occurs, the extra screen outputs the settings configured
in Main Menu > DISPL AY > Tour > Sub Screen.
This function is available on select models.
To use this function, extra screen shall be enabled.
Click Save to save the settings.
5.12.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
On the home page, select IoT > Management > Temperature/Humidity.
Temperature/Humidity
To Next Page
Loading...
Need help?
General
