HDCVI Standalone DVR User’s Manual
Figure 5-102
Check the box here to enable this function.
It is to set the interval from current channel group to the next
channel group.
Support 1-window split only.
Select a channel group and then click to delete it.
Click or to adjust channel tour sequence.
Add channel group
Click ,you can see system pops up the following dialogue box. See Figure 5-103.
Please select the channels and then click OK button.
Figure 5-103
Delete channel group
Select a channel group and then click ,you can delete it.
Modify channel group
Select a channel group and then double click, you can see the following interface. See
Figure 5-104. You can change the setup and then click OK button.
To Next Page
Loading...
