DH-PFM881 User Manual All Right Reserved
Page 30
WAN Mode：WAN mode can be configured to DHCP/PPPoE/Static IP. When set
to DHCP, the device can dynamically get the IP address; otherwise, user needs to
manually set the IP address, Netmask, gateway and other information.
WAN IP：WAN IP address. It should be set to the same segment of IP address of
the internet provided by ISP, please check with the ISP for this information.
WAN Netmask：WAN Netmask, use can check with the ISP for this information.
Note: WAN IP address should not be the same as the IP devices of the internet to
avoid collision.
Primary DNS and Secondary DNS: Please check with the ISP for the information.
Gateway IP：The IP address of WAN gateway.
7.2 Bridge mode
In Bridge mode, there is no WAN port. The LAN port of the POE adaptor, and the
LAN2 port of the DH-PFM881 device can all be the LAN port, and the user can
choose one of them to use as LAN port. Please refer to Figure 3 for the
connections in Bridge mode, and the IP address/Netmask information setting is
the same as Router mode.
7.3 Management
The IP address of the device can be modified, and the management of the device
can be performed by setting the specified management interface.
7.4 Firewall
When the firewall is enabled, the device can allow only some devices to be
associated to. Shown in Figure 23, and there are 4 cases of Firewall filtering.
To Next Page
Loading...
Need help?
General
