Select to configure parameters of the card.
There is one option: IPv4.
MAC address of the access controller.
Static
Set IP address, subnet mask, and gateway address manually.
DHCP
After DHCP is enabled, IP address, subnet mask, and gateway
address cannot be configured.
If DHCP is effective, IP address, subnet mask, and gateway address
will be displayed automatically; if DHCP is not effective, IP address,
subnet mask, and gateway address will all be zero.
If you want to see the default IP when DHCP is effective, you need
to disable DHCP.
Enter IP address, and then configure subnet mask and gateway address.
IP address and gateway address must be in the same network segment.
Set IP address of the preferred DNS server.
Set IP address of the alternate DNS server.
Click OK to complete the setting.
4.9.2 Port
Set the maximum connections clients that the access controller can be connected to and port
numbers.
Select Network Setting > Port.
Configure port numbers. See the following table.
Except max connection, you need to reboot the access controller to make the
configuration effective after modifying values.
Table 4-12 Port description
You can set the maximum connections of clients that the access controller
can be connected to.
Platform clients like Smart PSS are not counted.
Default value is 80. If other value is used as port number, you need to add
this value behind the address when logging in through browsers.
To Next Page
Loading...
Need help?
General
