67
Select Network Setting > P2P.
Select Enable to enable P2P function.
Click OK to complete the setting.
Scan the QR code on your web interface to get the serial number of the access
controller.
Safety Management
4.10.1 IP Authority
Select a cybersecurity mode as needed.
IP authority
4.10.2 Systems
4.10.2.1 System Service
There are four options: SSH, PWD Reset Enable, CGI, and HTTPS. Refer to "3.12 Features” to
select one or more than one of them.
The system service configuration done on the web page and the configuration on the Features
interface of the access controller will be synchronized.
To Next Page
Loading...
