User's Manual
30
4 Starting the Device
Background Information
●
For device security, connect the NVR to the power adapter first and then connect the
device to the power socket.
●
The rated input voltage matches the device power button. Make sure the power wire
connection is OK. Then press the power button.
●
Always use the stable current, if necessary UPS is a best alternative measure.
Procedure
Step 1 Connect the device to the monitor and then connect a mouse.
Step 2 Connect power cable.
Step 3 Press the power button on the front panel or turn on the power switch on the rear
panel to start up the device.
After the device starts, the system is in multiple-channel display mode by default.
The Device will verify license during starting up. If the verification failed, the icon
is displayed on the screen. Contact the technical support.
To Next Page
Loading...
