3 Basic Function Introduction
3.1 Call User
3.1.1 Connect
VTO is connected to VTH via network connection. At VTO, You can touch the button
to call all VTHs of designated user. During connecting, you can touch the button on VTO
to end call at any time.
3.1.2 Call
Under connecting status, if the call is picked up by any VTH, other VTHs will enter
standby status (These VTHs may join call by pressing call button, or enter monitoring
status by pressing monitor button.), and you will enter calling status. Each VTH that joins
the call may end call independently from other VTHs.
3.2 Monitor
Video captured by this VTO can be viewed from multiple VTHs.
3.3 Issue Card/Delete Card
3.3.1 Issue Card
Press menu button on VTH to issue card. Press SOS button to switch menu and
select to issue card. VTH will then enter issuing card mode, and you will see prompt
saying issuing card on screen. Now swipe card at card reading area until you hear a beep
which means you have successfully issued card. Press touch button on VTO to exit.
3.3.2 Delete Card
Press menu button on VTH to enter deleting menu. Press SOS button to switch menu
and select to delete card. You shall confirm deletion by pressing call button. After deletion
completes, you will see prompt saying delete card successfully.
To Next Page
Loading...
Need help?
General
