15
Device properties Figure 4-10
Click Confirm. Step 3
Table 4-4 Device properties description
The door station can be used as unit door station and fence station. Select
according to places where door stations are installed.
888888 by default. The default value cannot be modified.
Building No. range is 0-99999. Click next to the input box to enable
the building No. input function, and then enter the No. of the building
where the door station is installed.
Unit No. range is 0-9999. Click behind the input box to enable the
building No. input function, and then enter the No. of unit where the door
station is installed.
VTO No. range is 8001-8099. Enter No. of the door station (VTO) that you
are operating.
VTO No. can only be modified when the door station you are
operating does not work as a SIP server.
If there are more than one door stations (VTO) in a unit, the numbers
of the door stations (VTO) cannot be the same.
To Next Page
Loading...
Need help?
General
