17
6 User Registration
Only users whose information, including username, personnel number, room number,
fingerprint, and card number, is registered can unlock doors.
Press "*project password#" on the door station (VTO) to go to the Engineering Setting Step 1
interface.
On the Engineering Setting interface, select User Registration. Step 2
Select Add. Step 3
Enter user ID and Room No. Step 4
Press # to save the settings. Step 5
User registration Figure 6-1
Record face images and issue cards. Step 6
Face entry: Make sure that your face is in the middle of the frame. User face images will be
automatically taken. If you are not satisfied, tap Cancel to take a new image.
(Only for VTO 6541H) Fingerprint: at most three fingerprints of one user can be recorded.
Each fingerprint needs to be recorded three times. Operate according to voice prompt.
Issue card: You can issue at most five cards for each user. Swipe cards on the card issuing
interface, card numbers will automatically be recognized.
Issue cards through authorized cards.
Before issuing cards, you need to have an authorized card. If there are no
authorized cards, you need to issue a card on the door station (VTO) through
password.
On the web interface of the door station, select Household Setting > Room No.
Management > , and then you can set a card as an authorized card.
Issue cards through password.
You need to enter Issue Card Password on the web interface of the door station (VTO)
in Local Setting > Access Control > Local.
To Next Page
Loading...
Need help?
General
