How to resolve a duplicate ID error on a Daihen OTC Welbee WB-P320E bus?
If there is a duplicate ID on a single bus in your Daihen Inverter system: * Turn off the power switches of all other CAN-connected welding power sources. * Turn on the power switches and check the setting of internal function F43. The error code will disappear when the power switch is turned off.
What to do if phase W is not connected on Daihen OTC Welbee WB-P320E?
If phase W of the input voltage for the primary side is not connected on your Daihen Inverter, check the input voltage for the primary side and the cable wiring for any issues. The error code will disappear when the power switch is turned off.
What causes water-cooled pump issues in a Daihen OTC Welbee WB-P320E?
If your Daihen Inverter's water-cooled pump is behaving abnormally, check for water leakage from the cooling water hose and ensure sufficient cooling water is available. When using an air-cooled torch, verify that the LED of the TORCH key on the operation panel is off.
General| Output Current | 320A |
|---|---|
| Cooling Method | Forced air cooling |
| Output Current Range | 320A |
| Welding Process | MMA |
| Duty Cycle | 60% |
To Next Page
