SiBE121123_A Function of RA Indoor Unit
Function and Control 68
How to Set the Temperature and Airflow Rate
When using HOME LEAVE operation for the first time, set the temperature and airflow rate for
HOME LEAVE operation. Record your preferred temperature and airflow rate.
1. Press the [HOME LEAVE] button.
Make sure [ ] is displayed on the remote controller display.
2. Adjust the temperature with or as you like.
3. Adjust the airflow rate with the [FAN] setting button as you like.
HOME LEAVE operation will run with these settings the next time you start HOME LEAVE
operation. To change the recorded information, repeat steps 1 – 3.
Others
The set temperature and airflow rate are memorized in the remote controller. When the
remote controller is reset due to replacement of battery, it is necessary to set the
temperature and airflow rate again for HOME LEAVE operation.
The operation mode cannot be changed while HOME LEAVE operation is being used.
Initial setting Selectable range
Temperature Airflow rate Temperature Airflow rate
Cooling 25°C 18 ~ 32°C 5 steps, ,
Heating 25°C 10 ~ 30°C 5 steps, ,
To Next Page
Loading...
Need help?
General
