Operation manual
6
BRC315D7
Remote controller
4PW64949-1 – 10.2010
The remaining hours are displayed after the settings
are completed.
6. Maintenance
The remote controller does not need maintenance.
Remove dirt with a soft damp cloth.
7. Troubleshooting
The guidelines below might help to solve your
problem. If you cannot remedy the problem, consult
your installer.
No readings on the remote controller (display
blank)
Check if the mains power is still applied to your
installation.
Only is displayed
This indicates that the installation has just been
powered, please wait until disappears.
I cannot enable the ON/OFF timer (the
icon is displayed)
The ON/OFF timer can not be enabled when a
centralised control is connected.
NOTE Only use clear tapid water to moisten the
cloth.
OFF timer = 3 hours
ON timer = 4 hours
Stop operation after 3 hours
1 hour left until the
operation starts
All settings are finished
To Next Page
Loading...
