Daikin Comfora FTXTP-M - Operation; Operation Range; When to Use Which Feature

5 | Operation
User reference guide
17
FTXTP-M_FTXTP-N
Daikin room air conditioners
4P728152-3 – 2023.03
5 Operation
INFORMATION
The indoor unit is delivered with the wireless remote control as the user interface.
This manual describes only operation with this user interface. If another user
interface is connected, refer to the operation manual of the connected user
interface.
5.1 Operation range
Use the system in the following temperature and humidity ranges for safe and
effective operation.
Cooling and drying
(a)(b)
Heating
(a)
Outdoor
temperature
RXTP-A -10~46°CDB -30~24°CDB
-31~18°CWB
RXTP-R -10~46°CDB -25~24°CDB
-26~18°CWB
Indoor temperature 18~32°CDB
14~23°CWB
10~30°CDB
Indoor humidity ≤80%
(b)
—
(a)
A safety device might stop the operation of the system if the unit runs outside its
operation range.
(b)
Condensation and water dripping might occur if the unit runs outside its operation range.
5.2 When to use which feature
You can use the following table to determine which features to use:
Feature Tasks
Basic features
Operation modes and
temperature
To start/stop the system and to set the
temperature:
▪ Heat up or cool down a room.
▪ Blow air in a room without heating or cooling.
▪ Decrease the humidity in a room.
▪ In Automatic mode, automatically select an
appropriate temperature and operation
mode.
+ Airflow direction
To adjust the airflow direction (swing or fixed
position).
Airflow rate
To adjust the amount of air blown into the
room.
To run more quietly.
Advanced features