Daikin DR80TC - Page 6

     7
DD80TC Dimensions
Minimum Clearances to Combustible Materials
  


SW B
1 0 3  1 1
Approved for line contact in the horizontal posion.
 

W D H A B
   
 
     
     
     
¹ 24” clearance for serviceability recommended.
² Single Wall Vent (SW) to be used only as a connector. Refer to the venng tables outlined in the
Installaon Manual for addional venng requirements.
10-7/8"
18-3/8"
19-5/8"
28-1/2"
33-1/2"
A
B
GAS INLET
LOW-VOLTAGE
ELECTRICAL
HIGH-VOLTAGE
ELECTRICAL