What does OD CTRL FAIL1 mean on my Daikin DX17VSS421AA?
- MMr. Michael RomanSep 12, 2025
If your Daikin Air Conditioner displays 'OD CTRL FAIL1', it may be due to high electrical noise. If necessary, replace the control board.
What does OD CTRL FAIL1 mean on my Daikin DX17VSS421AA?
If your Daikin Air Conditioner displays 'OD CTRL FAIL1', it may be due to high electrical noise. If necessary, replace the control board.
What does HPS OPEN mean on my Daikin DX17VSS421AA Air Conditioner?
If your Daikin Air Conditioner displays 'HPS OPEN', the high-pressure switch (HPS) might be inoperable. Check the resistance on the HPS to verify its operation and replace it if needed.
What to do if my Daikin DX17VSS421AA shows NO COOLING TEST?
If your Daikin Air Conditioner is showing 'NO COOLING TEST', it means that heat is being provided by a secondary heating source. Turn off any furnace or heater using the thermostat before operating the air conditioner.
Energy Efficiency Ratio (EER) | Up to 12.5 |
---|---|
Heating Season Performance Factor (HSPF) | Up to 9.5 |
Refrigerant Type | R-410A |
Operating Voltage | 208/230V |
Phase | 1 |
Seasonal Energy Efficiency Ratio (SEER) | 17.0 |
Warning about high voltage and disconnecting power before servicing.
Warning about qualified personnel for installation and service.
Guidelines for choosing an appropriate installation location for the unit.
Warning about potential explosion risks related to refrigerant cylinders.
Warnings about proper grounding, disposal, and installation practices.
Procedure for leak testing and warnings about fire/explosion and nitrogen cylinder safety.
Steps for vacuum, leak testing, electrical connections, grounding, and copper conductors.
Critical notices for installers and guidelines for communication wiring.
Table for calculating total and additional refrigerant based on line set length.
Navigation to Equip Test and procedure to activate System Test.
Procedure to set CHARGE MODE to OFF to terminate it.
Notices for refrigerant handling and procedure for subcooling measurement.
Tables for liquid pressure-temperature and refrigerant charge adjustment.
Accessing diagnostics and system status monitoring menus.
Details on system setup, equipment test, and cool set-up options.
Information on airflow profiles and cooling run values adjustment.
Detailed breakdown of diagnostics and status monitoring submenu items.
Procedure to run the system verification test after installation.
Settings for maximum compressor RPS range and selection.
Warning about high voltage and notes on wiring diagrams and conductor types.
Warning about avoiding contact with charged areas and residual voltage during testing.
Troubleshooting steps for the system run test.
Troubleshooting network communication issues and dipswitch settings.
Instructions for navigating between different display screens (0-4).