11 | Configuration
Installer reference guide
163
EWAA011~016DA + EWYA009~016DA
Packaged air-cooled water chillers
and packaged air to water heat pumps
4P620242-1 – 2020.06
In menu… You can read out…
[8.3] Dealer information Contact/helpdesk number
[8.4] Sensors Room temperature, outside
temperature, leaving water
temperature,…
[8.5] Actuators Status/mode of each actuator
Example: Unit pump ON/OFF
[8.6] Operation modes Current operation mode
Example: Defrost/oil return mode
[8.7] About Version information about the system
[8.8] Connection status Information about the connection
status of the unit, the room thermostat
and WLAN.
[8.9] Running hours Running hours of specific system
components
11.6.8 Installer settings
Overview
The following items are listed in the submenu:
Installer settings
Commissioning
Information
User settings
User profile
[9] Installer settings
[9.1] Configuration wizard
[9.3] Backup heater
[9.5] Emergency
[9.7] Water pipe freeze prevention
[9.8] Benefit kWh power supply
[9.9] Power consumption control
[9.A] Energy metering
[9.B] Sensors
[9.C] Bivalent
[9.D] Alarm output
[9.E] Auto restart
[9.F] Power saving function
[9.G] Disable protections
[9.H] Forced defrost
[9.I] Overview field settings
[9.N] Export MMI settings
Configuration wizard
After first power ON of the system, the user interface will guide you using the
configuration wizard. This way you can set the most important initial settings. This
way the unit will be able to run properly. Afterwards, more detailed settings can be
done via the menu structure if required.
To Next Page
Loading...
