ESIE05-04 Wiring Diagrams
Part 1 ā System Outline 1ā69
A1P Printed circuit board Wired remote controller
C1 Capacitor (M1F) R1T Thermistor (Air)
F1U Fuse (F5A, 250V) SS1 Selector switch (Main/Sub)
HAP Light emitting diode (Service monitor-green)
KPR Magnetic relay (M1P) Wireless remote controller (Receiver/display unit)
M1F Motor (Indoor fan) A3P Printed circuit board
M1P Motor (Drain pump) A4P Printed circuit board
M1S Motor (Swing flap) BS1 Push button (ON/OFF)
Q1M Thermo switch (M1F embedded) H1P Light emitting diode (on-red)
R1T Thermistor (Air) H2P Light emitting diode (timer-green)
R2T Thermistor (Coil~1) H3P Light emitting diode (filter sign-red)
R3T Thermistor (Coil~2) H4P Light emitting diode (defrost-orange)
S1L Float switch SS1 Selector switch (Main/Sub)
T1R Transformer (220~240V/22 V) SS2 Selector switch (Wireless address set)
V1TR Phase control circuit
X1M Terminal strip Connector for optional parts
X2M Terminal strip X33A Connector (Adaptor for wiring)
RC Signal receiver circuit X35A Connector (Group control adaptor)
TC Signal transmission circuit X40A Connector (Remote ON/OFF, Forced OFF)
X60A, X61A Connector (Interface adaptor for Sky Air series)
To Next Page
Loading...
