Need help?Do you have a question about the Daikin FCQ71KVLT and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Model | FCQ71KVLT |
| Cooling Capacity | 7.1 kW |
| Heating Capacity | 8.0 kW |
| Refrigerant | R32 |
| Energy Efficiency Ratio (EER) | 3.5 |
| Energy Efficiency Ratio (Cooling) | 3.5 |
| Energy Efficiency Ratio (Heating) | 4.0 |
| Power Supply | 220-240 V |
| Power Source | Electric |
| Noise Level (Outdoor) | 50 dB |
Press buttons to release and pull down the air filter. Disengage latch holes from protrusions.
Disengage top strings, open grille to 45 degrees, and unlatch the 3 bottom latches.
Remove corner covers, strings, and 4 screws. Unlatch outer and inner latches to remove the panel.
Unscrew 4 back screws and 4 front screws. Remove 4 seal parts and pull out the inner frame.
Remove heat insulation from inner frames and corners. Unscrew 8 bearing mounting plates.
Remove anti-sweat part, unscrew motor casing, disconnect relay harness, then remove the swing motor.
Unfasten two screws and slide to remove the switch box lid.
Disconnect flow switch, thermistor, fan motor, and drain pump connectors.
Unscrew two screws to detach and remove the switch box.
Unfasten screws and slide to remove the switch box lid for access.
Disconnect various wiring connectors and the ground cable from the PCB.
Press tabs to detach and remove the printed circuit board (PCB).
Remove three mounting screws, disconnect wiring, and slide the bell mouth forward.
Remove drain socket cap, discharge water, unscrew four screws, and pull down the drain pan.
Remove washer-faced nut and lock bracket, then pull out the fan rotor downward.
Disconnect motor connector, remove washer-faced nut, and take out the fan motor.
Cut cable tie, pull drain hose, unscrew pump assembly screws, and remove bracket.
Unscrew float switch assembly, slide protrusions laterally, and remove the float switch.
Remove switch box lid, disconnect humidity thermistor connector, and pull out the assembly.
Pull out plastic casing, press tabs to detach the humidity thermistor, and disconnect its connector.
Cut cable tie and pull the thermistor with heat insulation in the indicated direction.
To Next Page