Daikin FLKS25BAVMB - Removal of Electrical Box; PCB

Indoor Unit SiENBE05-722_A
122 Removal Procedure
1.7 Removal of Electrical Box / PCB
Procedure Warning Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Step Procedure Points
1. Remove the PCB.
 Clamp the harnesses and
wires with clips as they were
when reassembling.
Negligence of above
procedure may result in
catching wire with the front
panel and may cause
malfunction.
1
Disconnect the earth
wire and pull out the
indoor heat exchanger
thermistor.
2
Disconnect the 2 relay
harnesses at the rear
side of the fan motor.
3
Remove the electrical
box cover.
(Unfasten the 2 hooks.)
Indoor heat exchanger thermistor
Earth
(R3006)
Fan motor
(R3007)
(R3008)
Electrical box cover
Hook
SiENBE05-722_A.pdf 131 24/02/2011 14:06:02