SiENBE05-722_A Operation Manual
System Configuration 55
To adjust the vertical blades (louvers)
• When adjusting the louver, use a robust and stable stool and
watch your steps carefully.
Hold the knob and move the louvers.
(You will find a knob on the left side and the right side
blades.)
Notes on flap and louvers angles.
• Unless [SWING] is selected, you should set the flap at a near-
horizontal angle in COOL or DRY mode to obtain the best
performance.
• In COOL or DRY mode, if the flap is fixed at a downward
position, the flap automatically moves in about 60 minutes to
prevent condensation on it.
ATTENTION
• Always use a remote control to adjust the flap angle.
If you attempt to move it forcibly with hand when it is swinging,
the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the air outlet, a
fan is rotating at a high speed.
DRY
COOL
FAN
HEAT
To Next Page
Loading...
