SiENBE05-722_A Operation Manual
System Configuration 61
ATTENTION
To use ON TIMER operation
• Check that the clock is correct. If not, set the
clock to the present time.
1. Press “ON TIMER button”.
• 6:00 is displayed.
• “ ”blinks.
2. Press “TIMER Setting button” until the
time setting reaches the point you like.
• Every pressing of either button increases
or decreases the time setting by 10
minutes. Holding down either button
changes the setting rapidly.
3. Press “ON TIMER button” again.
• The TIMER lamp lights up..
To cancel the ON TIMER operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers
is shown below
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote control.
2
1, 3
4
Display
(Example)
Combined
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
To Next Page
Loading...
