Daikin FT35DVM - Removal of Electrical Box; PCB; Swing Motor

FT15DV2S, FT50/60DSG Si01-501
184 Removal Procedure
2.4 Removal of Electrical Box / PCB / Swing Motor
Procedure Warning Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Step
Procedure Points
1. Removing the front grille.

Parts layout
2. Removing the drip proof
plate.
1
Loosen the screw.
3. Disconnect the indoor
heat exchanger thermistor
and the earth.

Mind that not to lose the clip
for the thermistor.