13
HOME LEAVE Operation
HOME LEAVE operation function is useful when
you leave the house or the room.
How to use HOME LEAVE Operation
∗ This function is only available in COOL and
HEAT modes.
■■
■■
■ To use the “HOME LEAVE
Operation”
Press while the air conditioner
is operating.
(The HOME LEAVE lamp lights up.
)
■■
■■
■ To cancel the “HOME LEAVE
Operation”
Press again.
(The HOME LEAVE lamp goes off.
)
Before using HOME LEAVE Operation...
● When using HOME LEAVE Operation for the
first time, set the temperature and air flow
rate for HOME LEAVE Operation.
The initial settings are:
Heating ... Temperature 25°C Air flow rate AUTO
Cooling ... Temperature 25°C Air flow rate AUTO
■■
■■
■ How to set the temperature and
air flow rate.
Press .
Adjust the set temperature with
as you like.
1
2
3
Adjust the air flow rate setting with
FAN
as you like.
∗ The temperature and air flow rate will be the
same as the previous settings starting with
the second use.
∗ If you want to change the settings from the
previous use, repeat steps 1 through 3.
What’s it the HOME LEAVE Operation
● What is HOME LEAVE Operation?
Using HOME LEAVE Operation
During heating... It prevents the temperature in
the room from dropping too far
on cold winter days by using
weak heating operation (*1).
Disengaging HOME LEAVE
Operation will return the room
to the set temperature right
away.
During cooling... It prevents the temperature in
the room from rising too high on
hot summer days by using weak
cooling operation (*1).
Disengaging HOME LEAVE
Operation will return the room
to the set temperature right
away.
(*1)... You can change the set temperature and air
flow rate as you wish. Refer to the “Before
using home leave operation” section above on
how to change the settings.
To Next Page
Loading...
Need help?
General
