8
Receiver
Preparation Before Operation
■■
■■
■ Setting the batteries
2
3
1
Position + and
– correctly!
Address switch
About batteries
● When replacing the batteries, use
batteries of the same type, and replace
the two old batteries together.
● When the system is not used for a long
time, take the batteries out.
● When the operation display screen of the
remote controller is hard to see and the
reception become hard, replace the
batteries with new AAA batteries.
● The attached batteries are provided for the
initial use of the system.
The usable period of the batteries may be
short depending on the manufactured date
of the air conditioner.
ATTENTION
■■
■■
■ Operating the remote controller
●
To use the remote controller, aim the transmitter at
the indoor unit. If there is anything to block signals
between the unit and the remote controller, such as
a curtain, the unit will not operate.
●
Do not drop the remote controller. Do not get it wet.
●
The maximum distance for communication is about
7 m.
●
To remove, pull it upwards.
ATTENTION
Remote controller
holder
Set.
Push.
1
2
■■
■■
■ To fix the remote controller
holder on the wall
Choose a place from where the signals reach
the unit.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
1
2
3
Remote controller
Press with a finger and slide the back
cover to take it off.
Set two dry batteries (AAA).
Set the back cover as before.
● This will cause the figures on the display
to flash. Set the clock at this point.
1
2
3
About the remote controller
● Never expose the remote controller to
direct sunlight.
● Dust on the signal transmitter or receiver
will reduce the sensitivity. Wipe off dust
with soft cloth.
● Signal communication may be disabled if
an electronic-starter-type fluorescent lamp
(such as inverter-type lamps) is in the
room. Consult the shop if that is the case.
● If the remote control signals happen to
operate another appliance, move that
appliance to somewhere else, or consult
the shop.