SiENBE12-713 Instruction
System Configuration 161
FTK(X)S 20/25/35 C
CAUTION
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
UNITS
"
Indoor unit, outdoor unit and remote control
1. Wipe them with dry soft cloth.
"
Front panel
1. Open the front panel.
• Hold the panel by the tabs on the two sides
and lift it until it stops with a click.
2. Remove the front panel.
• Supporting the front panel with one hand,
release the lock by sliding down the knob
with the other hand.
• To remove the front panel, pull it toward
yourself with both hands.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, dry
it with cloth, dry it up in the shade after
washing.
4. Attach the front panel.
• Set the 3 keys of the front panel into the slots
and push them in all the way
• Close the front panel slowly and push the
panel at the 3 points (1 on each side and 1 in
the middle.)
• Check to see if the rotating axis in the upper
center section is moving.
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
To Next Page
Loading...