Instruction SiENBE12-713
200 System Configuration
NOTES
"
To cancel WEEKLY TIMER operation
11.Press “WEEKLY button” to deactivate the
WEEKLY operation.
• The “ ” will disappear from the display.
• The TIMER lamp goes off.
•
To reactivate the WEEKLY TIMER operation,
press the “WEEKLY button” again
.
"
WEEKLY TIMER
• Do not forget to set the time on the remote control first.
• The day of the week, time and ON/OFF can be set with WEEKLY TIMER. For ON-TIMER, settings other than the above
are based on the remote control settings just before the operation.
• The “WEEKLY button” activates or deactivates the reservation.
• To set WEEKLY TIMER, press “ button” and make a reservation according to the procedures.
• Only the time and set temperature set with the weekly timer are sent with the “ button”. Set the weekly timer only
after setting the operation mode, the fan strength, and the fan direction ahead of time.
• Up to 4 settings per day and up to 28 settings per week can be reserved with WEEKLY TIMER. If a reservation
deactivated with “WEEKLY button” is activated once again, the last reservation made will be used.
• Cooling: The unit operates at 18°C even if it is set at 10 to 17°C.
• Heating: The unit operates at 30°C even if its set at 31 to 32°C.
• Shutting the breaker off, power outages, and other similar events will render operation of indoor unit’s internal clock
inaccurate. Reset the clock. (page 8.)
• The “BACK button” can be used only for the mode, time and temperature settings. It cannot be used to go back to the
reservation number.
11
To Next Page
Loading...
