■English 2
English
N002
Accessories
–
Choosing an Installation Site
Before choosing the installation site, obtain user approval.
1.
Indoor unit
The indoor unit should be sited in a place where:
1) the restrictions on installation specified in the indoor unit installation drawings are met,
2) both air inlet and air outlet have clear paths met,
3) the unit is not in the path of direct sunlight,
4) the unit is away from the source of heat or steam,
5) there is no source of machine oil vapour (this may shorten indoor unit life),
6) cool (warm) air is circulated throughout the room,
7) the unit is away from electronic ignition type fluorescent lamps (inverter or rapid start type) as they may shorten the
remote controller range,
8) the unit is at least 1m away from any television or radio set (unit may cause interference with the picture or sound),
9) no laundry equipment is located.
2.
Wireless remote controller
Turn on all the fluorescent lamps in the room, if any, and find the site where remote controller signals are properly received by
the indoor unit (within 6m).
• This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for
commercial and household use by lay persons.
• Sound pressure level is less than 70 dB (A).
Mounting plate
1
Titanium apatite photocatalytic
air-purifying filter
2
Wireless remote
controller
1
Remote
controller holder
1
Dry battery AAA. LR03
(alkaline)
2
Indoor unit fixing screw
(M4 × 12L)
2
Screw cover
2
Operation
manual
1
Installation
manual
1
Indoor unit
A J
A B C
D E F
G H J
01_EN_3P358178-1A.fm Page 2 Monday, December 16, 2013 3:59 PM
To Next Page
Loading...
Need help?
General
