■English 10
ADJUSTING AIRFLOW DIRECTION · COMFORT AIR-
FLOW MODE · COOLING BREEZE · AIRFLOW RATE
More comfortable airflow is provided with airflow direction and airflow rate adjustment.
■
To change vertical and horizontal airflow directions
1. Press “ ” or “ ” during operation.
The horizontal and vertical louvers respectively move vertically and horizontally automatically.
■ If you want to fix airflow direction
2. Press “ ” or “ ” again.
■ To use 3-D AIRFLOW
3. Press “ ” and then “ ” during operation.
The horizontal and vertical louvers move alternately.
■ To cancel 3-D AIRFLOW
4. Press “ ” or “ ” again.
■
COMFORT AIRFLOW MODE and COOLING BREEZE operation
5. The indication will change every time “ ” is pressed.
■
COMFORT AIRFLOW MODE operation
•
The airflow direction and airflow rate are adjusted so that the air from the unit
does not blow directly on the occupants of the room.
•
< COOLING/DRYING> The flap will go up.
•
<HEATING/HUMIDIFYING> The flap will go down.
•
The airflow rate is set to “AUTO”.
■
COOLING BREEZE operation
•
COOLING BREEZE operation is for COOLING, “SARARA” DRYING and
FLASH STREAMER AIR PURIFYING operation.
■ To change the airflow rate
6. Press “ ” during operation.
(Refer to right table.)
•
COOLING or HEATING with “ ” or other weak airflow rate may not cool or heat
the room sufficiently.
•
Indoor unit quiet operation
When the air flow is set to
“”
, the noise from the indoor unit will become quieter.
6
5
1, 2
3, 4
• The airflow direction indication will display.
(In case of vertical direction)
• The vertical and horizontal airflow direction indications will display.
Displays COMFORT
AIRFLOW operation
Displays COOLING
BREEZE operation
Indication disappears
Operating mode
“SARARA” DRYING
DRY COOLING
MOISTURIZING
AUTO / COOLING
HEATING
HUMID HEATING
“URURU” HUMIDIFYING
FLASH STREAMER AIR PURIFYING /
FRESH AIR SUPPLY VENTILATION
Airflow rate setting
•
•
•
•
•
•
•
•
•
•
: COMFORT AIRFLOW MODE operation is possible.
: COOLING BREEZE operation is possible.
Five levels of air flow rate setting from “ ” to “ ” plus “ ” “ ”
are available.
NOTE
•
If the unit is operated with the horizontal louvers pointed down and stopped in COOLING, “SARARA” DRYING, or DRY COOLING operation,
the louvers will move automatically after about one hour. (This it to prevent condensation from forming on them.)
■
ATTENTION
•
Be sure to use the remote controller to adjust the airflow direction. Manual operation of the louvers may cause it to work improperly.
■
Note on COMFORT AIRFLOW MODE operation
•
The airflow direction is as fig. 1;
■
Note on COOLING BREEZE operation
•
The vertical movement of the horizontal louvers with “1/ f breeze”
rhythm provides comfort air like natural breeze. The room temperature
is felt cooler with cooling breeze.
■
Note on Adjusting the vertical airflow direction
•
The movable area for the horizontal louver is different depending on the
operation mode.
■
Note on 3-D AIRFLOW
•
Using 3-D AIRFLOW circulates cold air, which tends to be collected at
the bottom of the room, and hot air, which tends to be collected near
the ceiling, throughout the room, preventing areas of cold and hot from
developing.
A) FLASH STREAMER AIR PURIFYING ·
FRESH AIR SUPPLY VENTILATION · Individual operation
B) “SARARA” DRYING · COOLING
C) HEATING · “URURU” HUMIDIFYING
A) 15˚– 70˚
B) 20˚– 60˚
C) 30˚– 70˚
A)
15˚– 55˚
B)
45˚– 55˚
C)
25˚– 55˚
STOP
COMFORT
AIRFLOW
COOLING 15˚
COMFORT AIRFLOW
COOLING 15˚
COMFORT AIRFLOW
HEATING 75˚
COMFORT AIRFLOW
HEATING 65˚
Fig.1
Fig.2
01_EN_3P190650-1D.fm Page 10 Tuesday, March 6, 2007 6:26 PM
To Next Page
Loading...
Need help?
General
