7 ■English
OPERATION
COOLING · “SARARA” DRYING Operation
■ COOLING operation
•
1. Press “ ”.
•
2.
Press “ ”.
* It is recommended to switch to COOLING operation if you want to lower tempera-
ture preferentially during DRY COOLING operation.
■ “SARARA” DRYING operation
•
3. Press “ ”.
■
To change the airflow direction and airflow rate
(page 10.)
•
The airflow rate is set to “AUTO” during DRY COOLING or “SARARA” DRYING oper-
ation. Airflow rate cannot be changed.
■ To stop operation
4. Press “ ”.
The multi-colored indicator of the unit will go off.
■ To change the temperature or humidity setting
1
3
2
4
To lower temperature
G
reen
To lower temperature and humidity
Yellow
To lower humidity
Yellow
COOLING
Green Yellow
18˚C – 32˚C –3˚C – STD
OFF HIGH STD LOW CONT HIGH STD LOW CONT
DRY COOLING DRY
NOTE
■
Note on ON / OFF button
•
Pressing “ ” will start the same operation as the last time.
■
Note on COOLING operation
•
This air conditioner cools the room by blowing the hot air in the room outside, so if the outside temperature is high, performance drops.
■
Note on DRY COOLING
•
Pressing the humidity button down in COOLING mode set the unit to DRY COOLING.
•
Removes more humidity than the normal COOLING operation. It is recommended, however, to set temperature slightly lower than the room
temperature to lower humidity because this operation mode does not heat air supplementary.
■
Note on “SARARA” DRYING operation
•
Removes humidity with less lowering of the room temperature by heating air supplementary.
•
The operation mode change from COOLING to “SARARA” DRYING may raise humidity temporarily.
01_EN_3P190650-1D.fm Page 7 Tuesday, March 6, 2007 6:26 PM
To Next Page
Loading...
Need help?
General
