To change the airfl ow rate setting
Press .
DRY mode AUTO or COOL or HEAT or FAN mode
The airfl ow rate setting is not variable.
Five levels of airfl ow rate setting from
“
” to “ ” plus “ ” and “ ” are available.
Indoor unit quiet operation•
When the airfl ow is set to “
” , the noise from the indoor unit will become quieter.
Use this when making the noise quieter.
The unit might lose capacity when the airfl ow rate is set to a weak level.
Each pressing of the button advances the airfl ow rate setting in sequence.•
Auto Indoor unit quiet Low Middle low
MiddleMiddle highHigh
NOTE
Note on HEAT operation
Since this air conditioner heats the room by taking heat from outdoor air to indoors, the heating capacity becomes smaller in lower outdoor •
temperatures. If the heating effect is insuffi cient, it is recommended to use another heating appliance in combination with the air conditioner.
The heat pump system heats the room by circulating hot air around all parts of the room. After the start of heating operation, it takes some time
•
before the room gets warmer.
In heating operation, frost may occur on the outdoor unit and lower the heating capacity. In that case, the system switches into defrosting
•
operation to take away the frost.
During defrosting operation, hot air does not fl ow out of indoor unit.
•
Note on COOL operation
This air conditioner cools the room by releasing the heat in the room outside. Therefore, the cooling performance of the air conditioner may be •
degraded if the outdoor temperature is high.
Note on DRY operation
The computer chip works to rid the room of humidity while maintaining the temperature as much as possible. It automatically controls temperature •
and airfl ow rate, so manual adjustment of these functions is unavailable.
Note on AUTO operation
In AUTO operation, the system selects an appropriate operation mode (COOL or HEAT) based on the room and outside temperatures and starts •
the operation.
The system automatically reselects setting at a regular interval to bring the room temperature to user-setting level.
•
Note on FAN operation
This mode is valid for fan only.•
Note on airfl ow rate setting
At smaller airfl ow rates, the cooling (heating) effect is also smaller.•
01_EN_3P228444-4J.indd 1101_EN_3P228444-4J.indd 11 10/12/2011 9:34:27 AM10/12/2011 9:34:27 AM
To Next Page
Loading...
