Adjusting the 3-D airfl ow direction
To start 3-D airfl ow
1. 3. Press the
and the :
the “ ” and “ ” display will light up and the
louvers and fi ns will move in turn.
To cancel 3-D airfl ow
2. 4. Press either the
or the .
COMFORT AIRFLOW operation
Check COMFORT AIRFLOW operation in the section of “COMFORT AIRFLOW Operation” and
•
“INTELLIGENT EYE Operation”.
Page 14,15
NOTE
Notes on louvers and fi ns angles
When “• SWING button” is selected, the louvers swinging range depends on the operation. (See
the fi gure.)
Three-dimensional (3-D) airfl ow
Using three-dimensional airfl ow circulates cold air, which tends to collected at the bottom of the •
room, and hot air, which tends to collect near the ceiling, throughout the room, preventing areas
of cold and hot developing.
ATTENTION
Always use a remote controller to adjust the angles of the louvers and fi ns. If you attempt to move •
it forcibly with hand when it is swinging, the mechanism may be broken.
Always use a remote controller to adjust the fi ns angles. In side the air outlet, a fan is rotating at a
•
high speed.
COOL and DRY operation
HEAT operation
FAN operation
Upper limit
COMFORT AIRFLOW
Lower limit
Stop operation
Stop operation
Upper limit
Lower limit
COMFORT AIRFLOW
Upper limit
Lower limit
Stop operation
10°
15°
50°
30°
70°
75°
15°
70°
01_EN_3P228444-4J.indd 1301_EN_3P228444-4J.indd 13 10/12/2011 9:34:31 AM10/12/2011 9:34:31 AM