34
Care and Cleaning
3-2 Titanium apatite photocatalytic air-purifying filter
The titanium apatite photocatalytic air-purifying filter can be renewed by washing it with
water once every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
3-2-1 Vacuum dusts, and soak in warm water
or water for about 10 to 15 minutes if dirt
is heavy.
• Do not remove the filter from frame when
washing with water.
3-2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of
polyester, do not wring out the filter when
removing water from it.
[Replacement]
3-2-3 Remove the tabs on the filter frame and
replace with a new filter.
• Do not throw away the filter frame. Reuse
the filter frame when replacing the
titanium apatite photocatalytic air-
purifying filter.
• Dispose of the old filter as non-flammable
waste.
4. Set the air filter and titanium apatite
photocatalytic air-purifying filter as they
were and close the front panel.
• Insert claws of the filters into slots of the front panel.
Close the front panel slowly and push the panel at
the 3 points. (One on each side and one in the
middle.)
NOTE
• Operation with dirty filters:
• To order titanium apatite photocatalytic air-purifying filter contact to the service shop there
you bought the air conditioner.
• Dispose of the old filter as non-flammable waste.
Push
(1) cannot deodorize the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
Item Part No.
Titanium apatite photocatalytic air-purifying filter
(without frame) 1 set
KAF970A46
01_EN_3P248442-3.fm Page 34 Tuesday, September 8, 2009 1:54 PM
To Next Page
Loading...
